Gang Rip Saw Racks

Our gang rip saw laser mounting racks are versatile, and very strong. They are easily installed onto any machine width, and accomodates up to 14 lasers. They can be configured with any number of rails, to attain spacing as low as 3/4" between the lines. Rip saw racks can be ordered fully outfitted or ordered minimally and added to as you add saws. The rails are 3/4" and 1/2" nitrosteel, offering years of use with no wear or rust. Setups are a snap thanks to the innovative trolley design which provides easy repeatability and tool free adjustment.

SA-011 Trolley

The SA-001 trolley is the heart of the rail system. The delrin ® bearings are retained with a snap ring, making bearing replacement painless. The clamp is tightened onto the shaft via a thumbscrew, and of course the bracket provides all the adjustments required for aligning the lasers to your machine.

• Trolley Includes:

• Delrin ® bearings (with retaining rings)

• Thumbscrew

• SA-039 Laser mounting ring

SA-003 Three Rail Sets

This three rail set comes with 3 sets of shafts at the standard length of 36" *

• Rail Set Includes:

• 3 bars 1/2" nitrosteel shaft

• 3 bars 3/4" nitrosteel shaft

• 2 end mounting brackets and setscrews

  
  
  

  * 72" maximum shaft length / length over 48", extra charges will apply.

SA-040 Individual Shaft Set

To order a custom assembly, order the number of these required to attain the spacing that you require.

• 1 Set Consist Of:

• 1 bar 1/2" nitrosteel shaft

• 1 bar 3/4" nitrosteel shaft

• Standard length 36"*

  
  

  * 72" maximum shaft length / length over 48", extra charges will apply.

SA-033 Rack End Mounting Brackets

When ordering a custom assembly. These are required.

• 1 Set Consist Of:

• 1 right bracket

• 1 left bracket

• Bracket required set screws